Anchorages for post-tensioning

Link to YUANXIAN

Anchorages are used to fix the ends of the tendons in post-tensioning systems. Various designs are available, depending on the system supplier, but basically they are steel blocks through which single or multiple strands pass and are anchored by wedges. The strands may be tensioned individually or as a group.

The anchorages are cast into the concrete and transfer the entire load from the strands into the concrete. This causes high local bursting forces. To prevent the concrete splitting additional reinforcement is required close to the anchorage.

Where high tensile strength bars used for prestressing, the bars are threaded (either just at the ends or over their whole length) and anchored after tensioning by means of nuts that bear against steel plates set in the concrete. Again addition reinforcement is needed to prevent bursting of the concrete.

What is Stressing Anchorage?

If you are looking for more details, kindly visit Concrete Post Tension Mono Anchorage supplier.

A Post Tensioning Anchorages is a mechanical device,
consisting of all components required
to transfer the post-tensioning force from the prestressing steel to the structure.

in addition, Its including all accessories for grouting.

Furthermore, Stressing anchorage is the most common form of post-tensioning system.

It is widely used in concrete structure and soil / rock retaining walls.

post tensioning anchorages consist of wedge, anchor head, bearing plate and spiral reinforcement.

Want more information on 12.5 Mm Pc Strand factory? Feel free to contact us.